Replaced the bottom seal on the dishwasher door. The old one had disintegrated a while ago and I was getting little water drops on either side of the door. Also replaced the main door seal while I was at it. This is after I replaced the heating element a few days ago since it went out. Good refresher and much cheaper than a new unit
I recently pulled apart all the plastic and screens I could and cleaned them from debris. Bought some dishwasher cleaner and the wife hasn’t asked to get a dishwasher since.
Nice! If there is a sensor down there with holes, it will also trap gunk. I had to pull mine completely out to clean it
I am about to replace my water intake and drain pump. Keep a good thought for me!
You got this. Dishwashers a pretty simple machines. And once you pull it out from under the countertop, there ain’t no pesky sheetmetal to deal with. Everything is out in the open.
That was my experience as well. The schematics on the manufacturer website were helpful and everything seemed pretty simple! Definitely got this!
Nice work!
Thanks!
I recently did this too! Except the heating element, I never use that. Now half my top rack clips that mount it to the slider rails are rusted and broken, but a new rack is hundreds of dollars 🙄 thinking I’ll just live with the jankiness for now.
Heating element made a huge difference in how clean my dishes got. That’s one of the reasons I noticed it went out - not nearly as clean
You never use the heating element in the dishwasher, i.e. only clean with cold water?
Oh that’s right, I ensure hot water is ready for it to use at the tap but forgot it is still used throughout the cycle. I just don’t use the heated dry is what I meant to convey
I need to do this as well. Was it any special seals or did you use some generic one?
Look up your model (should be on the sticker on the side where the door meets). Idk how they vary, but I was not happy when the heating element arrived and was not the right one. Even though the listing said it supported my model. Reviews are pretty helpful in figuring out if the listing lies
Take out the whirly twirly things and vacuum them out too. Many times, food debris gets stuck in there. plugs a jet. Things don’t end up as clean as they should. I had zip ties in one of mine at one point. But I also don’t prewash just give em a quick scrape and in they go.
That makes sense. I have not seen anything in them, but then again I did not look very hard. My sensor inside the sump was gunked up though. I tried vacuuming that and brought the gunk to the top of the sensor. Made the thing think it was full of water. Took another 4 hrs to realize what happened before I popped it out and cleaned it
Excellent work!
Thanks!
